r 0505

Vehicles must be inspected by a competent mechanic (may be yourself), technician or service facility prior to the event. You must bring this completed form to the morning on-site grid tech. When your vehicle is empty, raise your hood, make sure all drivers sign the form and slip it under your windshield wiper. You will be performing the tech inspection and certifying your vehicle is in proper working condition for this event. We cannot perform a full tech inspection at the event. You are fully responsible for the mechanical condition of your vehicle and completing the checklist prior to the event.

Driver #1 ______________________________ Driver #2 _________________________________               

Model _________________ Color __________________ License Plate # ___________________            

____ three point DOT approved seat belts in good working condition: required on both front seats
____ wheel bearings: tight, not binding
____ steering: no excessive wheel play
____ brake fluid: clean, reservoir full
____ brake pedal: firm
____ battery: securely mounted; caps tight
____ fan belt: good condition; no cracks
____ fuel lines: no leaks; good condition
____ throttle linkage: no sticking or sloppiness
____ engine hoses and wires: good condition; secure
____ engine mounts: no cracks or distortions
____ fuel lines and inlet: no leaks or wetness; good condition
____ glass: no severe cracks or scratches
____ windshield wipers: working; good condition
____ shock absorbers: firm; no leaks; securely mounted

The following items may be more easily checked while the vehicle is raised:

____ tires: 2/32" tread minimum; no excessive wear pattern or sidewall cuts
____ wheels: not bent; no cracks
____ brake calipers: clean, dry
____ brake pads/shoes: good condition; at least 1/3 of original thickness remaining
____ brake hoses, lines: dry, good condition
____ tie rods ends: tight
____ suspension location points: no cracks or excessive rust
____ engine/transmission/oil lines: no leaks
____ exhaust: good condition; muffler required
____ CV joints: no grease seepage or looseness
____ rear wheel bearings: no leaks
____ unusual conditions or modifications

Inspected by:___________________________________________                

Title/Organization/Self:____________________________________ Date:_________________

Important: Please have your car fully unloaded and ready for the event, (empty glovebox, floor mats removed) as soon you have completed emptying your vehicle raise your hood, make sure all Drivers sign the form and slip it under your windshield wiper. If your car's lug nuts are other than 19mm or 21mm, please have the appropriate ½" drive socket with you.

____ all deficiencies noted above corrected
____ front and rear glass: clean and unobstructed
____ brake fluid: clean; reservoir full; cap tight
____ wheel bearings: tight
____ tire pressure: adjusted for autocross conditions
____ lug nuts: none missing; tightened to manufacturer's specific torque; wheel locks removed
____ hub caps/rings: removed
____ gas cap: tight
____ all loose items removed from trunk and interior; glove box empty or locked
____ special accessories (cameras, g-analysts, etc.): securely installed
____ helmet: Snell 1995 or later sticker required. (helmets will be available for rent at the event if needed)
____ clothing: natural fibers (cotton or wool) or fire-resistant material - recommended; long pants, recommended; tennis shoes or rubber-soled shoes (not sandals)

To be signed on-site at Grid Tech:  Participant: ________________________________  On-site Witness: __________________________

I certify that the above inspections have been conducted according to the guidelines set forth and that all deficiencies marked have been corrected. I understand that I and I alone am liable for the condition and suitability of the vehicle listed for participation in this event. I release all parties involved with organizing this event and the Mazda Sportscar Club of Washington, Inc., from any liability arising from failure of this vehicle for any reason, including failure of the items listed on this inspection form.

Driver #1 ________________________________ (Date) ____________

Driver #2 ________________________________ (Date) ____________

After completion of your on-site tech inspection lower your hood, make sure your participant number is on your windshield, report to registration (MSCW Blue Awning) for check-in with this signed form and arrive at the drivers meeting on-time.
Note: On the day of the autocross, we recommend you have your tires properly inflated beforehand, at least a 3/4 tank of gas and your oil level full.